Design & Finish

• Living finish exterior will continue to patina
• 3/4" thick CoreAcryl white acrylic interior

Comfort & Operation

• Super quiet 1.25hp water pump
• Direction control on 4 back and 2 foot jets plus speed and direction control on 4 side jets
• Adjusting the side jets to low offers a more robust massage for the back and feet
• Waterproof remote control operation
• All jetted fittings housed between the tub inner and outer shell

Installation & Requirements

• Requires a freestanding or wall mount faucet
• Integrated drain and overflow in choice of finish
• All jet fittings are supplied in white
• This tub requires one standard 15amp-110volt GFCI connection (does not alter if heater added)

Safety & Compliance

• All electrical components are UL listed
• MA Code accepted

• Water Jetting
  Direction control on four back and two foot jets, variable speed and direction control on four side jets.
• Jet Pressure Control
Higher pressure on the back and foot jets can be achieved by turning the flange on the variable speed side jets and lowering their output.
• Fittings Position
The double shell tub design makes it possible to maintain the original bathtub appearance with no visible or remote jetting parts. All of the fittings are contained within the cavity in between the shells.
• Bath Salts and Bubble Bath
  It is safe to use bath salts and bubble bath. However, make sure the salts are dissolved before entering the bath or they can scratch the tub surface.
• Care and Maintenance
  Cleaning the high gloss acrylic finish requires a wipe down with a soft cloth and some very gentle liquid soap without abrasives. The living finish lightly aged copper exterior will continue to patina over time, unwanted marks can be removed using a soft damp cloth, a car polish or Mothers polish.
• Recommended Regular Maintenance
  

  To maintain excellent hygiene, we strongly recommend the following preventative maintenance be carried out each 1-2 months.

  • Fill you tub with warm water to 2" above the top jet.
  • Add two cups of household bleach.
  • Activate all the jets on in the fully open position.
  • Allow the jets to run for 15 minutes.
  • Switch the jets off and allow the water to sit for 15 minutes.
  • Empty the tub.
  • Re-fill with fresh water, again 2" above the top jet.
  • Run the jets for 15 minutes.
  • Empty the tub and the job is finished.
  • If the tub is not in constant use, it is still very important to continue the maintenance as described herein.